Hardware e Software > Connessioni ADSL/VDSL/FTTC
Is There Any Hope......
marven:
--- Citazione ---As for the old modem...well it is completely dead becuase the computer doesn't recognize it (A network cable is unplugged), all you get is the power status lead on.
--- Termina citazione ---
In adam2 mode the power led only is on, the modem isn't dead, it's only in coma status (perhaps it's happy with Eve, we don't know! :P ) so before considering it a paper holder, try again with adam2, with the recovery tool (ip address 192.168.0.99 gw 192.168.0.1 sm 255.255.255.0) and with adam2app (http://wireless.com.pt/forum/download.php?id=5459)
With adam2 and adam2app try the following Ip addresses:
169.254.87.1
192.168.0.100
10.48.88.66
192.168.178.1
10.1.1.1
5.8.8.8
10.8.8.8
192.168.1.1
192.168.0.1
put x.x.x.99 as ip address (change the xes with the proper nrs) and 255.255.255.0 as subnet mask...
--- Citazione ---Is it possible that the modem a new version and it protected from firmware upgrades...500T etc...?
--- Termina citazione ---
For what I know it isn't protected. I remember a similar problem was solved by a user sending the command "erase" via serial interface... I'll check the thread...
Maybe it's a problem of messing in the env variables, sometimes happens they show OK but are really wrong. If that's the case you could try to delete and rewrite them with the adam2app tool.
marven:
This is the thread I mentioned before
https://www.ilpuntotecnico.com/forum/i...t=45&#entry7134
But the problem was different... adam2 was apparently dead but really it was alive and accessible via serial port, that could be a solution for the other modem...
That user says he sent the "erase" command via serial port then ftp'ed to adam2 at the address 10.8.8.8 (I dont' know if he tried 10.8.8.8 via ethernet before...)
SilverDesertRain:
Thanks again marven,
I tried the adam2app but the old modem could not be revived because the ethernet port seems to be dead...I don't know how you can use the serial port ? There is no serial port in the modem, just USB and Ethernet. Do you connect the serial port to the USB via same adaptor ?
As for the new modem...still the same problem. The flash won't erase no matter what I try. I have tried the adam2app but when I try to send a file to the modem to the flash, the program crashes and does not repond. I can upload things from the modem like config and env.
Thanks for your patience... :(
marven:
--- Citazione ---how you can use the serial port ? There is no serial port in the modem, just USB and Ethernet. Do you connect the serial port to the USB via same adaptor ?
--- Termina citazione ---
The serial port is inside the modem. You have to open it. Look at the Ciclamab online help, there's a schematic of the serial adapter...
Here:
http://www.seattlewireless.net/index.cgi/ADAM2
you can read a lot about adam2 and the serial commands...
SilverDesertRain:
Thanks again...
The link is not working I'm afraid.
So isn't there any solution for the new modem...why will the flash not be erased ?
Thanks
Navigazione
[0] Indice dei post
Vai alla versione completa