ragazzi ho un modem adsl2+router pirelli v1.0 fornito da fastweb.Sul manuale di istruzione mi dice che lo posso usare come modem adsl normale aggiornando il firmware rtiportata nel cd
una volta fatto l'aggiornamento nn capiscvo come devo impostare i parametri per poter utilizzare io ho un abonamento a libero potete spiegarmi come settare i parametri
o indicarmi dove prendere la configurazione....!!!vi ringrazio vi mando la pagina di impostazione
Status
This page shows the status of your connection
--------------------------------------------------------------------------------
Status
PPPoE Connection: Cable disconnected
WAN IP Address: 0.0.0.0 WAN Settings...
Local IP Address: 192.168.1.1 LAN Settings...
--------------------------------------------------------------------------------
Advanced Diagnostics
Connection Authentication: PPPoE Username/Password PPPoE Settings...
PPPoE Dial-On-Demand: Disabled
IP address of PPP server:
Port Connection Status
Port Type Connected Line State
A1 atm N/A
Ethernet0 ethernet N/A
DMZ ethernet N/A
Usb-ethernet ethernet N/A
WAN Status
IP Address Type: Static IP Address Settings...
WAN Subnet Mask: 0.0.0.0
Default Gateway: None
Primary DNS: None DNS Client Settings...
LAN Status
LAN Subnet Mask: 255.255.255.0
Act as Local DHCP Server: Yes DHCP Server Settings...
MAC Address: 00:08:27:FB:58:DE
Hardware Status
Up-Time: 00:00:24s
Version: Pirelli Standard Code (Rel.1.5): Argon 4x2 Eval BSP v1.0 / Argon 4x1 CSP v1.0 (ISOS 9.0) [9.0.7.7]
Vendor: Conexant
Defined Interfaces
PPPoE WAN uplink: Show Statistics... Port:a1 VPI/VCI: 0/100
RFC1483 WAN uplink: Show Statistics... Port:a1 VPI/VCI: 0/101
ethernet0: Show Statistics...
usb-ethernet: Show Statistics...
Routing Table
Destination Netmask Gateway Interface
192.168.1.0 255.255.255.0 0.0.0.0 iplan
127.0.0.0 255.0.0.0 0.0.0.0 loopback
Webserver Status
HTTP Port: 80
Auxillary HTTP Port: 8008
--------------------------------------------------------------------------------
Copyright (c) 2004 Conexant Systems Ltd. Terms and conditions
