Hardware e Software > Connessioni ADSL/VDSL/FTTC

[GUIDA] Flash, Root e Modding Technicolor TG788vn v2 (VDNT-W)

<< < (36/87) > >>

FrancYescO:
cosa hai impostato come tipo di connessione banda larga? prova a impostare almeno per una volta eth

zeropool:
Ripristino il fw, risblocco e reinstallo la gui di ansuel. Provo la 9.3.52 vediamo come va

larsen64it:
Con l'ultima stabile 9.3.77 non dovresti avere problemi.
P.S. Quale versione di telmex hai installata, l'ultima è TG788vnv2_17.2.0360

zeropool:
si, questa : F_TG788vnv2_17.2.0360

gecon27:
Hello all,

I installed the TELMEX firmware, unlocked the router and installed the Ansuel GUI. So far everything is ok, VDSL is connected, BUT I cannot get an IP address.
I checked VLAN tag id and is correct (835), so I think the problem is the MTU which seems to be 1500 (I found this by ifconfig after connecting via ssh to the router) while on another router that works the MTU is 1492. I think also that 1492 is the max allowed MTU for pppoe connections. So the question is how can I change the MTU? Is it possible via the Ansuel GUI?

PS. I already disabled "Wan Sensing State" in the Broadband section as per larsen64it advise (refer to https://www.ilpuntotecnico.com/forum/index.php/topic,81285.0.html).

Thanks,
Giannis

Navigazione

[0] Indice dei post

[#] Pagina successiva

[*] Pagina precedente

Vai alla versione completa